Heavy Duty Finishing Mower

BLADE HEIGHT ADJUSTMENT

The mowers must be raised off the ground far enough to pull the wheel yoke (#5) out of the welded sleeves at the ends of the axles (#1). Be sure the tractor is turned off. Pull out the clip (#4) and remove the wheel yoke. There are ½” and 1” spacers to adjust the cutting height. The cutting height is 1 ¾” with no spacers under the sleeve at the end of the axles. This can be adjusted using the spacers by ½” increments up to 4 ¾”. Check to see that the spacers are set at the same height on all the wheel yokes.

BLADE HEIGHT ADJUSTMENT

ITEM PART# DESCRIPTION

1908942 67 1/2'' Axle Beam Weldment (5')

908944 69 1/2'' Axle Beam Weldment (6')

908946 71 1/2'' Right Axle Beam Weldment (7')

2902504 1/2'' Lg x 1 5/8'' OD Bushing (pl)

3902503 1'' Lg x 1 5/8'' OD Bushing (pl)

4966729 3/16'' Linch Pin (pl)

5

902422

Wheel Yoke

37

Page 41
Image 41
Buhler FK369 manual Blade Height Adjustment Item PART# Description