Bunn 41167.0001B service manual Cleaning, Sprayhead, Bin /Driptray

CLEANING

SPRAYHEAD

1.Open the pod door with the "OPEN/CLOSE" switch.

2.Disconnect brewer from power source and allow to cool.

3.Unscrew sprayhead counterclockwise (looking from below). Fig 8-1

4.Remove sprayhead and seal from holder.

5.Check and clean the sprayhead. The sprayhead holes must always remain open. Clean all the holes in the plastic sprayhead to remove any mineral deposits. Wash and rinse in sink. Fig 8-2

6.When reassembling sprayhead, be sure to have seal installed with ridge facing up (A). Fig 8-3

BIN /DRIPTRAY

1.Pull the driptray assembly straight towards you.

2.Pull the bin straight out and empty as required.

3.Seperate the parts as shown in Fig 8-4 and wash with mild, nonabrasive, liquid detergent.

4.Assembly is in reverse order.

REMOVE - CCW

INSTALL - CW

The use of a damp cloth rinsed in any mild, nonabra- sive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment.

A

FIG 8-3

FIG 8-1

FIG 8-2
SHOWN UPSIDEDOWN
FOR CLARITY		FIG 8-4
	Page 8	41167.1 051508