GLOSSARY

TANK TEMP XXX°

(-) EXIT (+)

READY TEMP XXX°

(-) EXIT (+)

SET CUP SIZE

EXMPL TIME

DISPENSE TO ADD

REPEAT SAVE

DRINK STRENGTH

(-) XX (+)

XX° CAL XX° (-) Tank Temp (+)

235 REFILL 155

(-) EXIT (+)

CAL WATER ?

PRESS DISPENSE

CAL POWDER ? PRESS DISPENSE

 

Auger Delay

 

(-)

.XX sec

(+)

CAL HOPPER ?

NOYES

LOW POWDER LOCK ?

NO EXIT YES

DISPENSE LOCKOUT

NO EXIT YES

RINSE ALARM ?

NO EXIT YES

HEAD 1 DISABLE ?

NO EXIT YES

Adjust tank temperature (190° F maximum)

Adjust minimum tank ready temperature for lockout (185° maximum)

Select setting cup size by Time (seconds) or by Example (Portion Control models only)

Press same dispense button to top off cup, or press save to lock in dispense time, or, press repeat to erase dispense time and repeat process.

Adjust hopper motor speed for station selected

Calibrate temperature probe

Set refill probe threshold

Calibrates dilution water flow rate in station selected

Calibrates powder dispense rate for hopper in station selected

Set delay start of hopper after dilution valve opens in station selected

Calibrates hopper level sensor in station selected Hopper must be at least half full to calibrate

Enables lockout of dispensing when low hopper level is detected

Enables lockout of dispensing if below minimum water temperature

Enables rinse alarm

Disables all functions and dispensing for station selected

SET PASSWORD ?

(-) XXXX (+)

AUDIBLE ALARM ? NO EXIT YES

DISABLE MESSAGES ? NO EXIT YES

ENABLE ADS ?

NO EXIT YES

ENTER ASSET # ? EXIT YES

ENABLE SERVICE #

NO EXIT YES

ENABL EngergySavr

NO EXIT YES

TEST SWITCHES ? Use Switch To Test

TEST HEATER ? EXIT YES

TEST REFILL ? EXIT YES

TEST HOT WATER ? EXIT YES

TEST AUGERS ? DISPENSE TO TEST

TEST DISP HEADS DISPENSE TO TEST

DISPLAY USAGE ? EXIT YES

FACTORY DEFAULTS

NOYES

Allows password to be set to prevent altering setup functions

Turns on audio alarm

Disables function that displays fault messages on LCD door display

Enables “ADS” to be displayed on LCD door display

Enter asset number of machine

Enables service agent telephone number to be displayed

Enables energy saver mode

Allows testing of dispense switches

Allows manually activating tank heater

Allows manually activating refill valve

Allows manually activating hot water valve (optional)

Allows manually activating hopper motors

Allows manually activating dispense valves & whipper motors

Displays amount dispensed

Resets all functions to factory defaults, and password to 0

7

37510 113004