PREPARING THE BREWER FOR USE
NOTE - THE BREWER IS NOT READY TO PLUG IN. Do NOT plug in until Step #3.
Step 1
Raise the hinged
NOTE: The post protruding from the screen is connected to a stopper which controls the flow of water into the tank. When lid is closed (post depressed), the stopper is raised and water will flow into the tank.
P2240
Step 2
Slide an empty brew funnel into the brewer under |
| |
the warmer switch. Pour one decanter full of water |
| |
into the screened area on top of the brewer. Place |
| |
decanter on the warmer. Close lid. Wait three minutes |
| |
to allow the water to flow into the tank. Repeat this |
| |
process. When the tank is full, some water will flow | P2247 | |
through the funnel and into the decanter. | ||
| ||
Step 3 |
| |
Plug in the brewer. |
|
Step 4 |
|
Press the bottom of the vacation switch, located on the |
|
lower left side of the brewer, to the "ON" (lower) position. |
|
The vacation switch controls power to the tank heater. |
|
Initially you will have to wait approximately fifteen |
|
minutes in order for the water to reach brew |
|
temperature. |
|
Empty any water that has collected in the decanter. |
You’re not done yet! The next page leads you through the five
easy steps to ‘BREWING DELICIOUS COFFEE’
6
