Bunn CDS-3 TROUBLESHOOTING cont, Problem, Probable Cause, Remedy, B Remove the strainer and check

TROUBLESHOOTING (cont.)
PROBLEM	PROBABLE CAUSE		REMEDY
Powder Auto-Fill will not dispense	1. No water		Water lines and valves to the dis-
product			penser must be open and free of
			obstructions.
	2.	No power or incorrect voltage to	Check that the power cord is con-
	the dispenser.		nected to the CDS dispenser and for
			voltage from the CDS dispenser.
	3.	Dispense Solenoid Valve	Refer to Service- Dispense Solenoid
			Valve for testing procedures. See
			page 32
	4.	Control Board and Probe	Refer to Service- Control Board and
			Probe for testing procedures. See
			page 18
	5.	Auger Drive	Refer to Service- Auger Drive for
			testing procedures. See page 13
	6.	Transformer	Refer to Service- Transformer for
			testing procedures. See page 26
	7.	Water Strainer (Optional)	A) Direction of flow arrow must be
			pointing towards dispenser.
			B) Remove the strainer and check
			for obstructions. Clear or replace.
Dripping from dispense tip	1. Dispense Solenoid Valve		Remove dispense valve and clear
			any obstructions. Rebuild or replace
			the valve if necessary. Seepage 32
Water flows continuously	1. Control Board and Probe		Refer to Service- Control Board and
			Probe for testing procedures. See
			page 18
	2.	Dispense Solenoid Valve	Refer to Service- Dispense Solenoid
			Valve for testing procedures. See
			page 32

10 29793 061599