Bunn CDS-2, CDS-3 service manual SERVICE cont, Auger Drive Components

SERVICE (cont.)

AUGER DRIVE COMPONENTS

P1922

FIG. 2 AUGER DRIVE COMPONENTS

Location

The auger drive components are located in the bot- tom of the hopper assembly.

Removal, Cleaning and Replacement

1.Open the dispenser door.

2.Lift the hopper assembly over the retainer plates

(16)on hopper support plate (12) and slide hopper assembly out the front of the dispenser.

3.Remove hopper lid (1) and empty product.

4.Pull off the ejector elbow (15) and remove the slide gate (21).

5.Remove retainer ring (11) and washer (10) from the bottom of the hopper base (9).

6.Remove wiper shaft (3), wiper blade (4) and wiper drive gear (5) from the hopper base (9).

7.Remove auger wire (14) by pulling it out the front of the hopper base (9).

8.Remove auger drive shaft (13) by removing the retaining clip (6) from auger drive shaft.

9.Slide spacer (8) and auger drive shaft bracket (7) off of the auger drive shaft (13).

10.Remove auger drive shaft (13) from hopper base

(9).

11.Wash components in a mild solution of dish deter- gent using a bristle brush when needed.

12.Rinse and dry each item thoroughly.

13.Check for damaged or broken components, re- place any if necessary and reassemble hopper assembly.

14.Install hopper assembly in the dispenser by sliding hopper assy on the hopper support plate (12) until the hopper base (9) seats firmly behind the re- tainer plates (16) on the hopper support plate (12).

	1
	2
	3
	4
	5
6	13
7
8	14
9	20
10
11	15
17	21
18
19
	16
	12
	P1894
	FIG. 3 AUGER DRIVE & HOPPER ASSEMBLY

1.	Hopper Lid	12.	Hopper Support Plate
2.	Hopper	13.	Auger Drive Shaft
3.	Wiper Shaft	14.	Auger Wire
4.	Wiper Blade	15.	Ejector Elbow
5.	Wiper Drive Gear	16.	Hopper Retainer Plates
6.	Retainer Clip	17.	Auger Motor Bracket
7.	Auger Drive Bracket 18.		Auger Motor
8.	Spacer	19.	Dust Seal
9.	Hopper Base	20.	Auger Motor Mounting
10.	Washer		panel
11.	Retainer Ring	21.	Slide gate

13 29793 061599