USER NOTICES
Carefully read and follow all notices on the grinder and in this manual. They were written for your protection. All notices on the grinder are to be kept in good condition. Replace any unreadable or damaged labels.
WARNING
Use only on a properly protected circuit capable of the rated load.
Electrically ground the chassis. Follow national/local electrical codes. 
Do not use near combustibles.
An extension cord, when used, must be shorter than 20 feet if
FAILURE TO COMPLY RISKS EQUIPMENT
DAMAGE, FIRE, OR SHOCK HAZARD
READ THE ENTIRE OPERATING MANUAL INCLUDING THE LIMIT OF WARRANTY AND LIABILITY BEFORE BUYING OR USING THIS PRODUCT
#20545.0000
PERSONAL INJURY
HAZARD.
KEEP FINGERS AND FOREIGN OBJECTS OUT OF HOPPER OR CHUTE OPENING.
#05876.0000
To reduce the risk of electric shock, do not remove or open cover.
No
#37881.0000
ELECTRICAL REQUIREMENTS
Refer to Data Plate on the Grinder, and local/national electrical codes to determine circuit requirements. This grinder has an attached cordset and requires
120 volts ac, 15 amp, single phase, 60 Hz, for domestic grinders.
230 volts ac, 10 amp, single phase, 50 Hz, for most international grinders. 100 volts ac, 15 amp, single phase, for some international grinders.
OPERATING CONTROLS
Grind Pad (a)
Pressing initiates a timed grind cycle.
Stop Pad (b)
Pressing ends the operation of the grinder.
® PAD (c)
Pressing the ¨ pad allows programming access (see page 6).
d
a
c
d
b
Hopper/Batch Selector Pads (d)
These pads are located on the funnel depictions on each side of the grinder with a total of 6 pads. Selecting one of these pads will select the amount of grind and side from which to grind.
Example: Selecting the lower pad on the left side will grind enough beans from the left hopper of the grinder to brew the amount programmed into grinder.
Control Board
The control board determines the amount of beans that will leave the hopper in a grind cycle. The timer portion can be adjusted to dispense a different amount from each hopper and each batch size. The scale is from 0.4 to 99.9 seconds. Refer to the Adjustments section for timer setting chart (page 7).
36529 080706
