Bunn G3, G2 Electrical Requirements, Ce Requirements, Initial Set-Up, Operating Controls

ELECTRICAL REQUIREMENTS

100VAC to 240VAC 50hz or 60hz require 2 wire with ground 15 amp service.

Note: Grinders with optional electrical receptacle must use 20 amp service. Not all models are available in all voltage configurations or with optional receptacle.

CE REQUIREMENTS

•This appliance must be installed in locations where it can be overseen by trained personnel.

•For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.

•Appliance shall not be tilted more than 10° for safe operation.

•An electrician must provide electrical service as specified in conformance with all local and national codes.

•This appliance must not be cleaned by water jet.

•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of this appliance by a person responsible for its safety.

•Children should be supervised to ensure they do not play with the appliance.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard. • Machine must not be immersed for cleaning.

INITIAL SET-UP

CAUTION - Unplug the grinder throughout the initial set-up.

1.Open the top lid. Clear all foreign objects and shipping materials from the hopper compartment and the entrance to the grind chamber.

2.The grinder can now be plugged-in and put into service.

OPERATING CONTROLS

Grind Selector

Allows the user to vary the grind for each coffee. Each setting will provide precisely the same grind every time it is selected.

Off/On/Start Switch

OFF/STOP - (upper position)

Switching to this position stops the operation of the grinder. ON - (center, resting position)

The switch will return to this position after a grind cycle has begun and will remain in this position after grinding has ceased.

START - (lower, momentary position)

Pressing the switch initiates grinding only when a bag is in place behind the chute or the brew cup is in place.

Bag/Brew Cup Sensor

Prevents the grinder from operating unless the back of a bag is in place behind the dispense chute or the brew cup is not in place. Do not attempt to bypass this safety device.

Cleaning Lever

Allows the operator to clean out any coffee residue left from the previous grind.

4 43254 051710