Bunn JDF-4S - page 6

INITIAL FILL

CAUTION: The dispenser must be disconnected from the power source throughout the initial ﬁll except when

speciﬁed in the instructions.

1. Remove drip tray assembly and splash panel from the dispenser. Replace the drip tray.

2. Connect the water source to the back of the dispenser.

3. Pull the ﬁll tube from the dispenser, remove the plug and connect it to the dispense nozzle.

4. Place the Dispense Lockout switch in the OFF position.

5. Connect dispenser to the power source. Press and hold the dispense button for the dispense station that the

tube is connected to for 10 seconds, until you hear the water valve turn on.

6. Monitor the water bath ﬁll level until water starts to trickle from the overﬂow tube. Then press the dispense

button again to stop the ﬁll process.

NOTE: The ﬁll timer may time out before ﬁlling is complete. Press and hold the dispense button for 10 seconds

to start again if needed.

FIG 1 Plumbing Connections - JDF-2S

PLUMBING HOOKUP

The plumbing connection is located on the rear of the dispenser. A 3/8" (9.52 mm) male ﬂare adapter ﬁtting

is supplied, installed on the rear of the dispenser.

P3580-1

FIG 3 Initial Fill Hose - JDF-2S

P3581-1

39992 042007

FIG 2 Plumbing Connections - JDF-4S

FIG 4 Initial Fill Hose - JDF-4S

P3841

P3846