Bunn MCAA manual Initial Brewer SET-UP, For pour-over set-up, go to Pour-Over Section on

“AUTOMATIC SECTION”

INITIAL BREWER SET-UP

For pour-over set-up, go to “Pour-Over Section” on page 12.

1. Remove the lid and water reservoir.

P3017

(CAUTION: Do not place the brewer in a sink or other water source.)

2.Thoroughly rinse the water reservoir.

3.Replace the reservoir

and lid and close the slide lid.

P2903

4. To ensure the Pod Holder

is locked in place, use thumb to press the pod holder release button to eject the holder and then press all the way in to lock.

P2965

(CAUTION: You should hear a clicking sound when the pod holder locks in place.)

5. Slide the volume control lever to the maximum setting.

P2959

6. Plug in the brewer and turn on the power switch.

P0214/2960

7.	Place a mug or bowl that
	will hold at least 414 ml
	(14 fl. oz.) onto the drip
	tray grate.	P2961
8.	Press and release
	the coffee brew
	button to fill the
	reservoir with

water.* P2958

9. Press and release the coffee brew

button again to fill

the internal	water
tank.*	P2958

(CAUTION: Water may not immediately flow from the brewer. Never remove pod holder from brewer during a brew cycle.)

10.Empty any water in the mug or bowl and place the mug back on the drip tray grate.

(NOTE: Wait for Heating Indicator to go out before proceeding to Step #11)

11. Press and release the coffee brew button a third time.*

P2958

(CAUTION: Water should flow from the pod holder. Wait until water drip out has finished before removing the pod holder.)

You are now finished preparing the brewer for it’s first use. Proceed to the “Brewing Delicious Coffee Or Tea” section.

*Some noise is normal when the water pump is running.

10