PERIODIC CLEANING/DESCALING (Cont.)
7)Place the empty cup or bowl back onto the drip tray grate and press the COFFEE BREW BUTTON to begin a brew cycle.
8)When the cycle has finished, empty the cup. Repeat step 7 at least two more times to remove the solution from the tank.
9)Clean the pod holder with a mild detergent and rinse thoroughly.
10)Proceed to the “Cleaning The Sprayhead/Seal” section.
| CLEANING THE SPRAYHEAD/SEAL |
|
1) | Press the Power Switch into the off “O” position. |
|
2) | Unplug the brewer and allow it to cool down. (Minimum of 1 hour.) |
|
3) | After the unit has been allowed to cool, remove the pod holder and set aside. | |
4) | Using your fingers, rotate the sprayhead/seal assembly |
|
| clockwise until the sprayhead and seal are removed. |
|
NOTE: If the sprayhead and seal are separated, they must be |
| |
reassembled as they were when removed from the brewer. |
| |
CAUTION: Improper reassembly could result in personal |
| |
injury from scalding water. |
| |
NOTE: See “Assembling Sprayhead/Seal” (Page 14) & |
| |
“Inspecting Sprayhead Seal” (Page 15) for more information. |
| |
5) | Clean the sprayhead and seal with a mild detergent and | P3015 |
6) | rinse thoroughly. |
|
Using your fingers, rotate the sprayhead/seal assembly | ||
7) | it is finger tight. |
|
Replace the pod holder. |
| |
8) | Plug in the brewer and press the POWER SWITCH to restore power to the |
|
| brewer. |
|
ASSEMBLING THE SPRAYHEAD/SEAL
| If the sprayhead and seal are separated during removal or cleaning, they must be | ||
reassembled properly. |
| ||
1) | Identify the top of the seal. The top of the seal that seats | Top | |
| against the roof of the sprayhead ramp has a rough |
| |
| ridge that can be felt by running your fingers across the |
| |
2) | surface of the seal. The bottom is smooth. |
| |
Identify the top of the sprayhead. The top of the | P2953 | ||
| sprayhead has a star pattern and a threaded hole where | ||
|
| ||
3) | the sprayhead attaches to the brewer. |
| |
While carefully stretching the seal, guide the sprayhead |
| ||
| into the channel of the seal. Make sure it is completely in |
| |
| the channel. | Top | |
| When properly assembled, the sprayhead will slide easily | ||
| P2953 | ||
into the channel of the seal and will not cause any buckles in | |||
| |||
the surface of the seal. If the sprayhead seems to be difficult |
| ||
to seat, and you must stretch the seal more than a slight tug, |
| ||
the assembly is not together correctly. |
| ||
CAUTION: Improper reassembly could result in personal |
| ||
injury from scalding water. | P2953 | ||
|
| ||
| 14 |
| |
