INITIAL BREWER SET-UP
1. Remove the lid and water reservoir.
P3017
(CAUTION: Do not place the brewer in a sink or other water source.)
2.Thoroughly rinse the water reservoir.
3.Fill the reservoir to the maximum line with
fresh cold water.
P2901
4. Replace the reservoir and lid and close the slide lid.
P2903
5. To ensure the Pod Holder
is locked in place, use 
thumb to press the pod 
holder release button to 
eject the holder and then 
press all the way in to
P2908
(CAUTION: You should hear a clicking sound when the pod holder locks in place.)
6. Slide the volume 
control lever to the 
maximum setting. 
P2952
7. Plug in the brewer and turn on the power switch.
P0214/2905
8. Place a mug or bowl that will 
hold at least 14 fl. oz. (414 
ml) onto the drip tray grate. 
P2904
9. Press and release 
the coffee brew 
button to fill the
internal water tank.
P2907
(CAUTION: Water may not immediately flow from the brewer. Never remove pod holder from brewer during a brew cycle.)
10.Empty any water in the mug or bowl and place the mug back on the drip tray grate.
(NOTE: Wait for Heating Indicator to go out before proceeding to Step #11) 
11. Press and release 
the coffee brew 
button a second
time.
P2907
(CAUTION: Water should flow from the pod holder. Wait until water drip out has finished before removing the pod holder.)
You are now finished preparing the brewer for it’s first use. Proceed to the “Brewing Delicious Coffee Or Tea” section.
9
