Bunn VPR APS service manual Service, Component Access, Contents, Control Thermostat

SERVICE

This section provides procedures for testing and replacing various major components used in this brewer should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem.

WARNING - Inspection, testing, and repair of electri- cal equipment should be performed only by qualified service personnel. The brewer should be disconnected from the power source when servicing, except when electrical tests are required and the test procedure specifically states to plug-in the brewer.

COMPONENT ACCESS

WARNING - Disconnect the brewer from the power source before the removal of any panel or the replace- ment of any component.

All components are accessible by the removal of the top cover and fill basin.

The top cover is attached with two #4-40 screws.

P2412-1

FIG. 1 COMPONENT ACCESS

The tank inlet fitting secures the fill basin to the tank lid.

	P2413
FIG. 2 FILL BASIN REMOVAL
Contents
Control Thermostat	9
Limit Thermostat	10
Tank Heater	10
Wiring Diagrams	12

CONTROL THERMOSTAT

P2414

FIG. 3 CONTROL THERMOSTAT

Page 8 39064 042806