Installation Instructions
for ‘09 d’lite™, Encore® and Solo™ (Euro) Child Trailers
Installation Instructions
for ‘09 d’lite™, Encore® and Solo™ (Euro) Child Trailers
Contents:
(1)Burley Owner’s Instruction and Safety Manual
(1)Hitch
(1)Clear light with batteries included
(1)Red light with batteries included
(2)Phillip Pan screws
(2) Brackets for lights
(1)Wheel guard assembly:
(2) wheel guards
(4) screws
(1) 5mm hex key wrench
Tools Required: Phillips screwdriver 4mm hex wrench
10mm or open end wrench
Note: Consult your Burley Owner’s Instruction and Safety Manual for wheel guard and hitch installation instructions.
Roll Bar Installation
1.If handle bar receivers are already installed, loosen and remove handle bar knobs and outer handle bar receivers.
Figure 1
2.Using wrench, loosen and remove lock nuts and screws from handle bar receivers.
3.From trailer front, slide roll bar into upper handle bar receivers, with curved front extending above trailer body.
4.Match holes in roll bar and inner handle bar receivers,
5.Replace outer handle bar receivers and tighten knobs.
| of | Trailer |
Front |
| |
| Screws | |
|
|
Roll Bar
| Rear Assembly |
Lock Nuts | Frame |
Handle bar
Knob
Inner Handle bar
Receiver
Outer Handle bar
Receiver
Contents:
(1)Burley Owner’s Instruction and Safety Manual
(1)Hitch
(1)Clear light with batteries included
(1)Red light with batteries included
(2)Phillip Pan screws
(2) Brackets for lights
(1)Wheel guard assembly:
(2) wheel guards
(4) screws
(1) 5mm hex key wrench
Tools Required: Phillips screwdriver 4mm hex wrench
10mm or open end wrench
Note: Consult your Burley Owner’s Instruction and Safety Manual for wheel guard and hitch installation instructions.
Roll Bar Installation
1.If handle bar receivers are already installed, loosen and remove handle bar knobs and outer handle bar receivers.
Figure 1
2.Using wrench, loosen and remove lock nuts and screws from handle bar receivers.
3.From trailer front, slide roll bar into upper handle bar receivers, with curved front extending above trailer body.
4.Match holes in roll bar and inner handle bar receivers,
5.Replace outer handle bar receivers and tighten knobs.
| of | Trailer |
Front |
| |
| Screws | |
|
|
Roll Bar
| Rear Assembly |
Lock Nuts | Frame |
Handle bar
Knob
Inner Handle bar
Receiver
Outer Handle bar
Receiver
FIGURE 1: Roll Bar Installation | FIGURE 1: Roll Bar Installation |
