CLEANING AND MAINTENANCE
Ensure the appliance is switched off and cooled down before cleaning. The case and surround are best cleaned with a damp cloth and wiped dry to avoid smearing. The glass is a special high temperature ceramic material, if possible clean with a damp cloth, for more stubborn stains use a ceramic hob cleaner such as
The inside of the glass and fuel effects should need only infrequent cleaning. To do this, lift the case off its clips and place to one side. Remove the 4 nuts and washers holding the glass clips in place and put safe. Carefully remove the fuel effects, remembering how they fit in place and clean around the burner area and fuel effects with a HEPA filtered vacuum with brush attachment. Using the relevant section from the installers manual refit the fuel effects, glass and case.
On no account should the fire be used with glass removed. The fuel effects must not be replaced in a different position from the instructions, if they are broken replace immediately. Do not use additional or non standard fuel effects as to do so could cause a hazard.
If the fire is equipped with a remote control then check and change the batteries as described in previously.
The fire should also be serviced annually by a competent person (CORGI registered in the UK). This is best done before a heating season.
NOTES
The first time that the appliance is used, there will be some odour produced due to the newness of thematerials. It is recommended that the unit is fired at maximum setting for several hours and the room is kept ventilated during this period. It is usual for flueless appliances to produce an initial odour after start up.
If the pilot flame should ever extinguish of its own accord, ventilate the room and allow a minimum of 5 minutes before relighting.
Never attempt to relight the unit if there is a gas smell.
If the unit continues to extinguish after a period of use, do not use it and seek the advice of your installer.
GENERAL
To qualify for your free second year guarantee, you must fully complete and return the separate Guarantee Card. There are sections that your fitter must complete whilst he is fitting the fire. If the fully completed Guarantee Card is not returned within 7 days of fitting, the appliance is just covered by the standard 12 month guarantee.
As with all gas appliances, this fire MUST be serviced at least every 12 months, preferably at the start of the heating season. The second year guarantee is conditional on this service taking place. Servicing must be carried out by a qualified service engineer.
BURLEY APPLIANCES ARE THE ONLY COMPANY TO BENCH RUN AND THOROUGHLY TEST EVERY SINGLE GAS FIRE IT PRODUCES. BURLEY ARE IN THE UNIQUE POSITION OF KNOWING THAT EVERY APPLIANCE LEAVES THE FACTORY IN PERFECT WORKING ORDER.
- 15 -
