To light the fire, first ensure the red knob is turned clockwise to OFF. Press the left hand (red) control knob for several seconds then turn slowly anticlockwise to the ignition position. A click will be heard and the pilot (under right side of fuel bed) should light. If it does not, repeat the operation a few times to purge any air in the pipe. Continue to hold knob for 15 – 20 second to establish the pilot and then release. If pilot fails to establish, turn off, wait 1 minute then repeat lighting procedure. Rotate the red knob to high flame to light then back to the desired flame position. If no gas comes through rotate the black knob (thermostat) to a hotter room setting and the fire will light.
Control the fire by a combination of thermostat and / or flame setting to suit your mode of use (see 9.1)
To turn the fire off, rotate the
Note that if the gas supply fails at any time, the pilot will extinguish. Carry out the lighting procedure to re- ignite.
REMOTE CONTROLLED HEATERS
Ensure the toggle switch behind the fret ash pan door is switched to the ON position. On the model G4238 you open the hinged frame to access it.
On first operation, ensure the thermostat is set to the hot position.
Ensure the infra red sensor is visible. The fire relies on line of sight between the sensor and handset to operate. If a different fret is fitted it is possible to swivel and slide the sensor into a clearer position. In the event of the fire not working check both of the above points before calling an engineer.
To ignite the fire point the handset at the fire, push and hold simultaneously the 2 left hand buttons marked * and ● for several seconds until the ignition sequence begins. The fire will automatically light the pilot light, monitor its safety for about 20 seconds and then it will light the burner on high flame.
To alternate between high and low flame use the flame buttons on the right hand side of the handset.
To turn the fire OFF press the ● button on the top left hand side of the remote handset.
The fire is fitted with a comfort thermostat behind the ash pan door and it is possible to set this to modulate the fire between off and on. If the pilot is alight but the main burner will not light, check the position of this thermostat before changing batteries etc.
An audible signal is heard when the fire receives a signal from the handset. This will help you to know that the fire has received your instruction and is changing settings. When the battery power is low, a continuous bleep will be heard from the fire and it will allow you to shut down safely but will not reignite.
Note that if the gas supply fails at any time, the pilot will extinguish. Carry out the lighting procedure to
REMOTE CONTROLLED FIRE BATTERIES
There is a toggle switch on the front of the appliance which needs to be switched on for appliance operation. Because the remote control uses battery power, when in the
A handheld remote control is included in the box and this has a 9 volt battery to power it. The battery should be changed annually to prevent false signaling caused by a partially flat battery. The battery is accessible through a flip off cover on the back of the handset and the battery clipped onto the terminals inside.
When disposing of batteries, always do so in an environmentally friendly manner.
Replacement lithium batteries for the fire and replacement handsets are available from Burley Appliances on 01572 756956 or through your retailer. The 9 volt handset battery is available from normal retail outlets.
- 14 -