Bush Hog RTC manual Stabilizer Bars Lift Arms

NOTE

If driveline is the correct length, omit the following steps “G” through “J” and proceed to step “K”.

G. Clamp driveline in a well padded vice to pre- vent damage to the shield. Cut off shield where marked. (Figure 2-3)

Figure 2-3

H. Using cut off section of shield as a guide, cut shaft the same amount. (Figure 2-4)

Figure 2-4

I. Repeat steps “G” and “H” to other driveline section.

J. Deburr ends of driveline sections and clean away all chips and fillings. (Figure 2-5)

K. Apply multi-purpose grease to inside of outer (female) driveline section. Assemble driveline and install on tractor and tiller. Pull on each driveline sec- tion to be sure yokes lock into place. Make certaqin driveline shielding is in place and in good condition.

DANGER

MAKE CERTAIN DRIVELINE YOKES ARE SECURELY FASTENED. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY.

Figure 2-5

L. Adjust lower lift arm to level tiller right to left. Refer to tractor operator’s manual for instructions.

M. Adjust top link of tractor 3-point hitch to level tiller front to rear.

N. Set up tractor stabilizer bars, sway blocks, or equivalent to prevent implement side sway. (Figure 2-6)

Figure 2-6

Stabilizer Bars

Stabilizer

Lift Arms

Stabilizer

8