Bush Hog RTC manual With the corresponding ones of the rigid cone

NOTE: In some instances, sliding the yoke shield back will make lubrication, inspection and cleaning of the universal joints more convenient. Proceed as follows:

1.Using a flat blade screwdriver, rotate the fasten- ing pin in its seat 1/2 turn until the head of the pin becomes unlocked in its housing on the cones. (Figure 4-2)

Figure 4-2

2.Lever up the pin through the slot, until the pin comes out. (Figure 4-3)

Figure 4-3

4.Remove the cones from the half-joint. (Figure 4-5) Figure 4-5

5.Remove the connecting ring from its housing on the yoke and, at the same time, from the slots of the guard tube, then move away the ring and the tube. (Figure 4-6)

Figure 4-6

3. Rotate the soft cone until the slots are aligned	Reassembly is in the reverse order
with the corresponding ones of the rigid cone.
(Figure 4-4)
Figure 4-4

11