NOTE
If dr iveline is the correct lengt h, omit the following steps “G” through “J” and proceed to step “K”.
G. Clamp driveline in a well padded vice to pre- vent damage to the shiel d. Cut of f shiel d where marked. (Figure
Figure
H. Using cut off section of shield a s a guide, cut shaft the same amount. (Figure
Figure
I. Repeat steps “ G” and “H” to other driveline section.
J. Deburr ends of driveline sections and clean away all chips and fillings. (Figure
K. Apply
DANGER
MAKE CERTA IN DR IVELINE Y OK ES ARE SECURELY FASTENED . FAILUR E TO DO SO MAY RESULT IN SERIOUS INJURY.
Figure
L. Adjust lower lift arm to level tiller right to left. Refer to tractor operator’s manual for instructions.
M. Adjust top li nk of t ractor
N. Set up tractor stabilizer bars, sway blocks , or equivalent to prevent implement side sway. (Figure 26)-
Figure
Stabilizer Bars
Stabilizer
Lift Arms
Stabilizer
2-2 OFFSETTING3-POINT HITCH (RTN Series)
The lower hitch pins on the RTN series can be offset up to 6 inches to eitherside as follows:
A. Loosen clamp bolts on hitch pin that will move outward and slide to desired position.
B.Remove opposite hitch pin bracket and replace it between clutch shield and “A” frame. A distance of 26- 7/8” , measured as shown in Figure
C.Tighten clamp bolts.
Figure
8