SECTION IV
MAINTENANCE
4-1 MAINTENANCE CHECK LIST
Perform scheduled maintenance as ou tlined b elow. Lower machine to gr ound, turn off tractor and set parking brake before doing maintenance inspections or work. Some checks may require raising machine off gro und and suppo rting with bl ocks. All bolts should be torqued as recomm ended in TORQUE SPECIFICATIONS, unless otherwise indicated.
BEFORE EACH USE
1.Check tra ctor tire air pre ssure. Refer to tractor operator’s manual.
WARNING
THE TILLER CAN FALL FROM HYDRAULIC SYSTEM FAILURE. TO AV OID SERIOUS INJURY OR DEATH, SECURELY SUPPORT TILLER BEFORE WORKING UNDERNEATH.
2.Check blades and rotor to be sure that no foreign objects such as wire or stee l strapping bands are wrapped around them.
3.Ch eck bla de bolts for tightness. Ti ghten t o 118 ft./lbs.
4.Inspect blades for wear. Replace if necessary.
5.Make certain driveline shields are in p lace and in good repair.
6.Perform BEF ORE EACH U SE lubricati on per paragraph
7.During o peration, l isten for abnormal sound s
which might indicate loose parts, damaged bear- ings, or other damage.
AFTER EACH USE
1.Clean all debris from machine especially underside.
2.Store in dry place.
4-2 LUBRICATION (Figure 4-1)
NOTE
The
BEFORE EACH USE
1.Driveline U niversal Joints - App ly
2.Driveline Guar d - Apply 2
3.Driveline - Disconnect PTO driveline, pull the two sections apart, ap ply th in coat of mul
4.Input Ge arb ox - Add
5.Lateral Gearbox - RTH Models (Gear Drive) - Add
6.Chain Drive - RTN,RTNR Models- Add
Figure
Lubrication
To remove yoke shield, depress the three tabs with a screwdriver and slide cover back.
RTH Gear Drive Oil Filler Plug
(5) Before Each Use
(1) Before Each Use
(3) Before Each Use
(2) Before Each Use
40HOURS
7.Rotor Shaft Bearing - Apply
(4)4Before Each Use
RTN Chain Drive
(7) 40 Hours
Oil | Filler Plug | Check Plug |
(6) | Before Each Use |
|
RTN Oil Check Plug
RTH Check Plug
10