G. Repeat steps “E” and “F” to other driveline sec- tion.
H.
I.Apply grease to inside of outer (female) driveline
Figure
Figure
section. Reassemble driveline and attach to tractor and implement. Pull on driveline section to make sure yokes lock into place.
J. Raise and lower implement to check for proper operation.
Figure
Figure
SECTION III
OPERATING PROCEDURES
3-1 TRACTOR REQUIREMENTS AND RECOMMENDATIONS
The tractor shall weigh a minimum of 6000 lbs. (2722 kg) not including ballast to prevent tractor upset. A PTO rating of not less than 50 horsepower
is required. The
Tractor should have front end ballast (weights) to help prevent front end skidding. Tractor should be equipped with Rollover Protective System (ROPS) and a seat belt used. Check chains for
WARNING
WHEN CUTTING WITH ANY SIDE MOUNT ROTARY CUTTER, IT IS LIKELY THAT SOME DEBRIS WILL BE THROWN TOWARD OPER- ATION. IT IS HIGHLY RECOMMENDED THAT OPERATOR BE PROTECTED BY ROLLOVER PROTECTIVE SYSTEM (ROPS) ENCLOSED CAB AND CUTTER DECK BE ENCLOSED BY FACTORY APPROVED PERMANENT BANDS OR SAFETY CHAINS. THE OPERATOR SHOULD WEAR SAFETY GLASSES AND SAFETY (HARD) HAT FOR PERSONAL PRO- TECTION.
3-2 OPERATION
A. Perform BEFORE EACH USE maintenance listed in Table
B. Make certain parking stand is pinned in the up position. (Fig.
C. Remove deck transport lock pin and place in storage holes. (Fig.
9