TWO-Year LIMITED WARRANTY
Your Bushnell® product is warranted to be free of defects in materials and workmanship for two years after the date of purchase. In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service Department.
Any return made under this warranty must be accompanied by the items listed below:
1)A check/money order in the amount of $10.00 to cover the cost of postage and handling
2)Name and address for product return
3)An explanation of the defect
4)Proof of Date Purchased
5)Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address listed below:
IN U.S.A. Send To: | IN CANADA Send To: |
Bushnell Outdoor Products | Bushnell Outdoor Products |
Attn.: Repairs | Attn.: Repairs |
8500 Marshall Drive | 25A East Pearce Street, Unit 1 |
Lenexa, Kansas 66214 | Richmond Hill, Ontario L4B 2M9 |
For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In Europe you may also contact Bushnell
at: | BUSHNELL Outdoor Products Gmbh |
| European Service Centre |
| MORSESTRASSE 4 |
| D- 50769 KÖLN |
| GERMANY |
| Tél: +49 (0) 221 709 939 3 |
| Fax: +49 (0) 221 709 939 8 |
This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2006 Bushnell Outdoor Products
TROUBLE SHOOTING TABLE
If unit does not turn on - LCD does not illuminate:
•Depress POWER button.
•Check and if necessary, replace battery.
•If unit does not respond to key presses, replace the battery with a good quality 9 volt alkaline battery.
If unit powers down (display goes blank when attempting to power the laser):
•The battery is either weak or low quality. Replace the battery with a good quality 9 volt alkaline battery.
•Heavy Duty alkaline batteries are NOT recommended.
If target range cannot be obtained:
•Make sure LCD is illuminated.
•Make sure that the power button is being depressed.
•Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that emit and receive the laser pulses.
•Make sure unit is held steady while depressing power button.
NOTE: The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using the LCD’s reticle, depress the power button and hold until new range reading is displayed.
Specifications, instructions, and the operation of these products are subject to change without notice.
18 | 19 |
