1001ST
This unit allows any stereo Audio/Video source, to distribute Audio and Video to different locations over standard coax cable. The RF output can be changed to any channel between 14 to 69 or cable channels from 65 to 125 (
| SPECIFICATIONS |
VIDEO |
|
Nominal Input level: | 1 Volt peak to peak |
Input Impedance: | 75 ohms |
Isolation port to port: | 32 dB |
Isolation out to input: | 60 dB |
Video bandwidth: | > 4 Mhz |
AUDIO |
|
Nominal Input level: | 1 Volt peak to peak |
Input impedance: | 22k ohm |
THD: | < 0.5% |
Frequency Response: | 20Hz to 14kHz |
Channel Separation: | >30dB |
Signal to Noise: | >60dB @ 2 Volts |
POWER
Requirement: External 9 Volt DC @ 250mA (minimum) with a 2.5mm Coaxial Center positive connector. Power Supply is included.
WARRANTY
Cable Electronics, Inc. warrants this product to be free from defects in material and workmanship, under normal use and service, for a period of one year from the purchase by the original purchaser. If this product is defective or malfunctions, Cable Electronics will replace or repair this unit (at their option) within a reasonable time. No expressed or implied warranty is made for any defects caused by immersion or exposure to liquids, abuse, neglect, improper operation of unit, excess wear and tear and defects resulting from unauthorized disassembly and or modification.
NOTE: *Please allow one channel spacing above and below the modulator tuned channel to prevent interference to existing channels.
*Press and hold the mode button to change the frequency output mode. Hold for at least 6 seconds or until display changes.
