IMI CORNELIUS INC.
One Cornelius Place
Anoka. MN
Telephone (800)
Facsimile (612)
INSTALLATION INSTRUCTIONS
“K” STYLE LID KIT, P/N 630000085
These “K” style kits apply to the following ice makers and are for use with DF/ED 200/250 dispensers:
|
|
| Ice Maker | Size |
|
| |
|
| Hoshizaki KM250/450/500/630/650 | 22I |
|
| ||
|
|
|
|
|
|
| |
|
|
|
| Table 1. |
|
| |
|
|
|
|
|
|
|
|
Item |
|
|
|
|
|
|
|
No. | Part No. |
|
| Name |
| Qty. | |
|
|
|
|
|
|
| |
1 | 630000310 |
| Lid Assembly, “K” Style |
|
| 1 | |
|
|
|
|
|
|
|
|
2 | 15303 |
|
| Bracket |
|
| 1 |
|
|
|
|
|
|
|
|
3 | 50904 |
|
| RTV, Clear, 732, 3 oz. Tube |
|
| 1 |
|
|
|
|
|
|
| |
4 | 630000311 |
| Cover, RH Assembly |
|
| 1 | |
|
|
|
|
|
|
|
|
5 | 70217 |
|
| #8 Sheet Metal Screw |
|
| 6 |
|
|
|
|
|
|
|
|
6 | 90221 |
|
| Label, Disconnect Before Cleaning |
|
| 1 |
|
|
|
|
|
|
|
|
7 | 70188 |
|
| Thumb Screw |
|
| 1 |
|
|
|
|
|
|
| |
8 | 630460040 |
| Installation Instruction |
|
| 1 | |
|
|
|
|
|
|
|
|
9 | 22127 |
|
| Bracket, LS Mounting |
|
| 1 |
|
|
|
|
|
|
|
|
1.Set Ice maker lid on the top of the dispenser and position it flush with the back and sides of the dispenser.
2.Using the slotted holes in the lid as a template, drill four (4) .140I diameter holes at the bottom of the slots (see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8 sheet metal screws, two on each side.
3.Seal the ice maker to the top of the dispenser as follows:
A.Apply beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so that the ice maker will set on the RTV.
B.Set the ice maker onto the lid and position it as required.
C.Wipe away any excess RTV.
4.Remove the two rear screws (only) installed in step 2. Use those screws to install the mounting brackets (item 2 and/or item 9). Drill 9/64I diameter holes into the ice maker cabinet using the bracket as a tem- plate. Use extreme caution not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using the screws provided.
5.Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the bin thermostat if so equipped or required.
9/16/97
630460040 | 1 |
Rev A
