Cables to Go 29573 manual Do the following before installation

SOFTWARE/DEVICE INSTALLATION

STEP 3 – DEVICE INSTALLATION FOR THE TRULINK WIRELESS VGA DEVICE ADAPTER

The TruLink Wireless VGA Device Adapter supports two association methods: Cable Association and Pin Association. Only one of these methods is necessary to complete installation. The instructions below describe steps for both methods, and how to use this adapter in Wired Mode. Please note that Pin Association is only recommended if using with a TruLink Wireless USB Host Adapter.

Do the following before installation:

™Make sure the antenna is connected to the Wireless VGA Device Adapter.

™Plug the supplied power adapter into your Wireless VGA Device Adapter.

™Be certain your Wireless USB host adapter is connected to the PC and necessary software has been loaded.

™Connect the Wireless VGA Device Adapter to your display using a VGA cable.

CABLE ASSOCIATION

1.Make sure the Wireless VGA Device Adapter Wireless/Wired switch is on Wireless. Using the supplied USB cable, connect the USB mini-b connector to the Wireless VGA Device Adapter USB mini-B port and USB A connector on the cable to an available USB port on your PC.

2.A cable association window pop-up will ask you if you would like to accept the association. Accept the association and unplug the USB cable.

3.Windows will automatically install the appropriate Wireless VGA Device Adapter drivers and you will get another successful install message pop up verifying successful installation. The installation is now finished and your Wireless VGA is ready for use.

11