Manuals / Brands / Computer Equipment / Switch / Cabletron Systems / Computer Equipment / Switch

Cabletron Systems 6H203-24, 6H253-13 B.3 INSTALLING OPTIONAL HIGH SPEED INTERFACE MODULES

1 62

Download 62 pages, 588.33 Kb

Installing Optional High Speed Interface Modules

Switch Settings, Upgrades, and Installations B-5

B.3 INSTALLING OPTIONAL HIGH SPEED INTERFACE MODULES

Figure B-4 shows the location of the two connectors for an optional High HSIM or VHSIM.

Depending on if an HSIM or VHSIM is installed, one or both connectors are used.

Figure B-4 HSIM and VHSIM Connector Locations

NOTE Refer to the installation instructions for the optional HSIM or VHSIM in the associated

user’s guide.

Optional HSIM

or VHSIM DRAM

HSIM/VHSIM Connectors

Contents

Main Page i Only qualified personnel should perform installation procedures. NOTICE ii FCC NOTICE INDUSTRY CANADA NOTICE VCCI NOTICE iii CABLETRON SYSTEMS, INC. iv v CABLETRON SYSTEMS SALES AND SERVICE, INC. vi vii CABLETRON SYSTEMS LIMITED viii ix DECLARATION OF CONFORMITY Page xi Contents 1 xii 2 3 INDEX 4 A Figures xiv Tables About This Guide USING THIS GUIDE Important Notice STRUCTURE OF THIS GUIDE RELATED MANUALS DOCUMENT CONVENTIONS The following conventions are used throughout this document: Introduction 1.1 OVERVIEW Important Notice Page Page 1.1.4 Full Duplex Switched Ethernet 1.1.5 SmartTrunk 1.1.6 Remote Monitoring (RMON) 1.1.7 Broadcast Suppression 1.1.8 Port/VLAN Redirect Functions 1.1.9 Rate Limiting 1.1.10 GARP Switch Operation 1.1.11 Flow Control 1.1.12 802.1 Port Priority 1.1.13 Management 1.1.14 Switching Options 1.1.15 Distributed Chassis Management 1.1.16 Optional HSIMs and VHSIMs 1.1.17 Standards Compatibility 1.1.18 LANVIEW Diagnostic LEDs 1.1.19 Year 2000 Compliance 1.2 GETTING HELP Page Network Requirements 2.1 SmartTrunk 2.2 10BASE-T NETWORK 2.3 100BASE-TX NETWORK Installation 3.1 UNPACKING THE MODULE 3.2 INSTALLING OPTIONS 3.3 INSTALLING THE MODULE INTO THE 6C105 CHASSIS Page 3.4 CONNECTING TO THE NETWORK 3.4.1 Connecting Twisted Pair Cables to Fixed Ports Page 3.5 COMPLETING THE INSTALLATION Troubleshooting 4.1 USING LANVIEW 4.1.1 The LED Mode Switch Page Using LANVIEW Speed Status 3380_4.1 Figure 4-1 LANVIEW LEDs Troubleshooting 4-3 Page Page 4.2 TROUBLESHOOTING CHECKLIST Page Page Page Page 4.3 USING THE RESET BUTTON 6H203-24 Page A Specifications A.3 ENVIRONMENTAL REQUIREMENTS A.1 MODULE SPECIFICATIONS A.2 PHYSICAL PROPERTIES A.4 INPUT/OUTPUT PORTS A.5 COM PORT PINOUT ASSIGNMENTS A.6 REGULATORY COMPLIANCE Page B Switch Settings, Upgrades, and Installations B.1 SETTING THE MODE SWITCHES Page B.2 SIMM UPGRADE B.2.1 Locating SIMMs B.2.2 Installing the DRAM SIMM B.3 INSTALLING OPTIONAL HIGH SPEED INTERFACE MODULES Page Index