Cabletron Systems manual Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitch

Installation

3.3.2Removing the 7H02-06 Module from a 7C03 MMAC SmartSwitch

To remove the 7H02-06 Module from a 7C03 MMAC SmartSwitch, follow the listed steps and refer to Figure 3-4.

Note: Before removing the 7H02-06Module, attach the wrist strap included with the module (instructions are printed on the packet).

1.Use a slotted screwdriver to loosen the two screws that secure the module to the chassis.

2.Locate the two ejector tabs on the module (to the right of the screws on the top and bottom of the module).

3.Simultaneously press down on the bottom ejector tab and press up on the top ejector tab until the module ejects from the backplane.

4.Grasp both ejector tabs and carefully slide the module out of the chassis.

Screws	Ejector
	Tabs

Figure 3-4. Removing the 7H02-06 Module from a 7C03 MMAC SmartSwitch

3-5