Cabletron Systems 9000 manual Installation, Tools Needed, Unpacking the Module, Chapter

Chapter 2

Installation

This chapter describes the physical layout of the 9G421-02/9G429-02 module and explains preparation and installation procedures for use in a SmartSwitch 9000 chassis. The 9G421-02/9G429-02 occupies a single slot in the SmartSwitch 9000 chassis. Install the 9G421-02/9G429-02 by following the steps in Unpacking the Module below.

Only qualiÞed personnel should perform installation procedures.

!Never expose the moduleÕs components to Electrostatic Discharge. Make sure you

CAUTION

have attached the moduleÕs disposable grounding strap to your wrist and always place the module on a non-conductive surface.

Tools Needed

¥Phillips screwdriver

NOTE

The INB Terminator modules must be installed on the rear of the chassis before powering up this module. Refer to the INB Terminator Modules Installation Guide for the installation procedure. The INB Terminator modules are essential to the proper operation of the bus on the chassis.

Unpacking the Module

1.Carefully remove the module from the shipping box. (Save the box and packing materials in the event it must be reshipped.)

2.Remove the module from the plastic bag. Observe all precautions to prevent damage from Electrostatic Discharge (ESD).

3.Carefully examine the module, checking for damage. If any damage exists, DO NOT install the module. Contact Cabletron Systems immediately.

2-1