Cabletron Systems 9H531-17, 9H532-17 , 2-7

2-7

Installing the SmartSwitch 9000 Module

Figure 2-2. Installing the 9H531-17 and 9H532-17 Modules

FLNK

INS

FLNK

INS

Circuit Card

Card Guides

Metal Back-Panel

Jack for ESD

wrist strap

Warning:Ensure that the circuit card is between the card guides.Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Contents

Main Page i VCCI NOTICE INDUSTRY CANADA NOTICE FCC NOTICE NOTICE ii CABLETRON SYSTEMS, INC. iii 4. 7. 6. CABLETRON SYSTEMS SALES AND SERVICE, INC. iv 7. CABLETRON SYSTEMS LIMITED v 6. 4. vi DECLARATION OF CONFORMITY Contents Page Chapter 1 Introduction Features Introduction 1-2 Figure 1-1. The 9H531-17 and 9H532-17 FAST ENET Page Page Page Page Related Manuals Getting Help Chapter 2 Installing the SmartSwitch 9000 Module Installing an HSIM or VHSIM Unpacking the Module User Accessible Components 2-3 2-4 at the end of this table. Cautions Using DIP Switch 6 Installing the Module into the SmartSwitch 9000 Chassis 2-7 Metal Back-Panel Figure 2-2. Installing the 9H531-17 and 9H532-17 Modules The Reset Switch Cabling Requirements 100BASE-TX Network 10BASE-T Network Page Chapter 3 Technical Overview SmartSwitch Architecture Technical Overview 3-2 System Management Buses SMB-1 Bus SMB-10 Bus System Diagnostic Controller DC/DC Converter INB Interface i960 Core Chapter 4 LANVIEW LEDs The LED Mode Switch LANVIEW LEDs 4-2 Page LANVIEW LEDs 4-4 Chapter 5 Specications Technical Specications Regulatory Compliance Service Physical