Cabletron Systems 9H532-17, 9H531-17 manual Switch Function Description

Installing the SmartSwitch 9000 Module

An eight-position DIP switch is located on the module card as shown in Figure 2-1. The function of the switches are listed in Table 2-1.

See the Cautions at the end of this table.

Table 2-1. Function of DIP Switch

Switch	Function	Description
		When toggled, this switch clears user-entered
8	Clear	passwords stored in NVRAM, and restores the
	Password 1	default passwords. Once reset you can use the
		defaults or enter new passwords.
		The module uses NVRAM to store user-
		entered parameters such as IP addresses,
		device name, etc. To reset these parameters to
7	Clear	the factory defaults, toggle this switch. Once
	NVRAM 2	reset, you can use the defaults or enter new
		parameters, which are stored in NVRAM
		when the module is powered down, and
		remain there until the switch is toggled again.
		Toggling this switch after pulling the board
		out of the SmartSwitch 9000, clears download
		information from NVRAM and forces image
6	Force BootP	files to be downloaded from the station
	Download	connected to the EPIM on the Environmental
		Module configured to act as that modules’
		BootP server. (See section titled Using DIP
		Switch 6 on page 2-5.)
5	Reserved	For Factory Use Only
4	Reserved	For Factory Use Only
3	Reserved	For Factory Use Only
2	Reserved	For Factory Use Only
1	Reserved	For Factory Use Only

2-4