CHAPTER 3: INSTALLATION
3-8 SEH USER’S GUIDE
If one end of a HubSTACK Interconnect cable is disconnected without
disconnecting the other end attached to the hub, ensure that you
disconnect the cable from the “OUT” port as shown in Figure 3-7. This
ensures that the HubSTACK Interconnect cable is terminated properly.
Figure 3-7. Disconnecting the HubSTACK Interconnect Cable
Proceed to Section 3.3 to connect power.
SEH INTERCONNECT
Disconnect SEH and SEHI Interconnect Cables
at the "OUT" Port.
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEHI-24
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEH-24
OUT IN
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEH-24
OUT IN
SEH INTERCONNECT OUT
1490_11
SEH INTERCONNECT
SEH Book Page 8 Tuesday, March 19, 1996 4:12 PM