Ring Speed

See the Cautions at the end of this table.

Table 2-1. Function of DIP Switch

Switch	Function	Description

		When toggled, this switch clears user-entered
8	Clear Password 1	passwords stored in NVRAM, and restores the
8	Clear Password 1	default passwords. Once reset you can use the
		default passwords. Once reset you can use the
		defaults or enter new passwords.

		The module uses NVRAM to store user entered
		parameters such as IP addresses, device name, etc.
	Clear NVRAM 2	To reset these parameters to the factory defaults,
7	Clear NVRAM 2	toggle this switch. Once reset, you can use the
		defaults or enter new parameters, which are stored
		in NVRAM when the module is powered down,
		and remain there until the switch is toggled again.

		Toggling this switch after pulling the board out of
	Force BootP	the SmartSwitch 9000, clears download information
6	Force BootP	from NVRAM and forces image ﬁles to be
6	Download	from NVRAM and forces image ﬁles to be
	Download	downloaded from the station conﬁgured to act as
		downloaded from the station conﬁgured to act as
		that modules’ BOOTP server.

5	Reserved	For Factory Use Only

4	Reserved	For Factory Use Only

3	Reserved	For Factory Use Only

2	Reserved	For Factory Use Only

1	Ring	Off = One ring of 24 ports (factory default)
1	Conﬁguration	On = two rings of 12 ports each
	Conﬁguration	On = two rings of 12 ports each

CAUTION

1Caution: Do not toggle Switch 8 unless you intend to reset the user conﬁgured passwords to their factory default settings.

2Caution: Do not toggle Switch 7 unless you intend to reset the user parameters to the factory default settings.

The module defaults to a 16Mbps ring speed on all rings. This may be changed though local management.

2-6