Cadet EPA1500/3, EPA750, EPA1000 warranty Operation Instructions, Removing Front Cover Screws Foot

READ ALL INSTRUC- TIONS AND SAFETY INFORMATION

Operation Instructions

PLACEMENT: For best results, place the Softheat baseboard heater under a window, along an outside wall, or as close as possible to an outside door.

This heater is a major electrical appliance and requires adequate electrical connec- tions for safe use. Plug the heater directly into a wall or floor receptacle when possible. If an extension cord is required, use only a heavy duty cord rated for 15 amps minimum. No other major elec- trical appliance should be operat- ing on the same outlet circuit.

STEP 1 HEATER INSPECTION

Carefully lift up and pull front cover forward from the bottom (See Figure 1).

Thoroughly inspect your heater for any shipping or handling damage and remove any paper or packaging material found inside the heater. If there is any indication that fluid has leaked, return the damaged heater to original purchase location.

Removing

Front Cover

Screws

Foot

HEATER OPERATION

Notice: This heater is a major electrical appliance and requires adequate electrical connections for safe use. Plug the heater directly into a wall or floor receptacle when possible. If an extension cord is required, use only a heavy duty cord rated for 15 amps minimum . No other major electrical appliance should be operating on the same circuit.

How To Operate Your Heater

NOTE: Before operating heater, HEATER INSPEC- TION Steps 1 through 3 must be completed:

1)Plug the electrical cord into a 120 volt (AC) out- let. The plug should fit tightly into the recepta- cle for a proper electrical connection.

2)Rotate the thermostat control knob clockwise until the light illuminates, indicating the heating element is on. Model EPA1500/3 multi-watt units have a second light (indicating the unit has power) and a wattage control switch. (See Figure 2)

3)Allow approximately one hour for the room tem-

WARNING!

Risk of Fire. Heater must be kept clear of all obstructions: 12- inch minimum clearance in front and above the heater with a 6-inch minimum on each side.

Figure 1.

STEP 2 REPLACING FRONT COVER

Place the hooks at each end of the front panel into the vertical slots located at each end of the heater. Push the cover back against the heater at the top until flush, then push downward on the cover. Cover should lock firmly into place and MUST be flush with the front before operating.

STEP 3 ASSEMBLY

The support feet must be securely attached to the heater as shown in Figure 1 BEFORE operat-

Indicator Light

Thermostat Control Knob

Wattage

Control Switch

Thermostat

Control Knob

Figure 2.

Model

EPA750 & EPA1000

Indicator

Lights

Model

EPA1500/3

WARNING! Risk of Electrical

Shock. Unplug the unit before performing any maintenance on heater. Failure to do so could result

in serious injury or death!

ing the heater. Two plastic support feet and four mounting screws are provided.

perature to completely stabilize. If the room is still too cool, turn the thermostat knob slightly clockwise to a higher setting. If the room is too warm, turn the thermostat knob slightly counter- clockwise to a lower setting. (Multi-watt mod- els: if the indicator light remains illuminated and the room is not warm enough, set the wattage control knob to the next higher rating.)

4)Once the room has reached a comfortable tem- perature, turn the thermostat control knob counter-clockwise until the indicator light goes out, and the thermostat will maintain room tem- perature.