CALIBRE
| The function will read the status a number of times before returning an error |
| condition - this number is defined by the MAXNUMBEROFGOES constant |
| defined in I2CINC.C, this value may be altered to suit your system. |
I2C status on exit | 0x00 bus busy and address sent and acknowledged |
| 0x08 bus busy and address sent but not acknowledged |
| 0x80 bus busy and address not sent. |
| (see Appendix A for details of Status codes). |
Example Usage: | (see also sample programs) |
/* This will send a start and the I2C Slave Address of the device to be communicated with. */ main()
{
int slaveaddress, setnack, i2cstatus;
slaveaddress = 0xa0; | /* I2C Address of slave, this is a typical */ |
| /* write for an I2C static RAM or EEPROM */ |
setnack = 0; | /* Enable Acknowledge (see parameter descriptions) */ |
i2cstatus = sendaddress(slaveaddress, setnack); switch i2cstatus
{
case 0x00:
printf("Start and I2C Slave Address sent and acknowledged\n"); case 0x08:
printf("Start and I2C Slave Address sent and not acknowledged\n");
default:
printf("Start not sent status is %x", i2cstatus);
}
}
4.2.4.I2C Read Data Byte from Slave Routine
Function definition: | int readbyte(int setnack) |
Usage: | i2cdata = readbyte(setnack); |
Function: | This is the function to read a byte of data from a slave device whose slave |
| read address has already been sent by sendaddress (or restart). It can be |
| used to disable acknowledge after reading data if it is the last but one byte to |
| be read. |
| Note: First byte read after |
| discarded. This byte should be ignored when working out when to |
| acknowledge/not acknowledge. |
Issue 1.3 | Page 9 |
22/07/99
