CALIBRE
3.3.27.RestartNoStatus
Function specification | void RestartNoStatus(int SlaveAddress, int SetNack, int NoTries) |
Parameters are: | int SlaveAddress |
| The address to be accessed via the I2C, e.g. A1H. |
| int SetNack |
| This controls whether the Adapter transmits an acknowledge down the I2C bus |
| on reception of a byte. The last byte received during a transfer must not be |
| acknowledged, in all other cases acknowledge must be enabled. If SetNack = 0 |
| then acknowledge is enabled, if SetNack = 1 then acknowledge is disabled. It is |
| normal to read data after a restart and hence SetNack will normally be 0. |
| Int NoTries |
Parameters returned | This is the number of times the Adapter is to try to send the address |
None | |
Prerequisites | Adapter must be configured using Setup. A start and slave address must have |
| previously been sent using SendAddressNoStatus. |
| Usually a data pointer would already have been written using |
| WriteByteNoStatus. |
Functional description | Sends a start code and the slave address. |
Issue 1.0 | Page 16 |
01/07/03 |
|
