Operation
Battery
Charge the battery for at least 10 hours before using the PA916 or
There are two indicators above the main power switch. When the unit is turned on, the one on the left will light ÒredÓ when the battery has a low charge. The one on the right will glow ÒgreenÓ if the battery is fully charged or if operating on A/C power.
It is recommended that the battery be recharged after several hours of usage, rather than stored with a low battery. This will prolong battery life. Storing more than 30 days without recharging will deteriorate the battery.
Digital Master Volume Control
When the main power switch is turned on, the Digital Master Volume Control is at the lowest level to prevent accidental damage to the amplier or internal speakers. The volume can be controlled in two ways; using the ÒUpÓ ÒDownÓ buttons on the mixer panel or using the
Recommended Set-up Procedure
Ideally the master volume should be at maximum volume before the wireless receiver and microphone volumes are adjusted to the desired loudness. Since there are always at least two (2) volume controls to contend with, it is suggested that prior to turning the power on the UHF receiver volume controls be set at Ò10 oÕclockÓ. Also set the microphone volume controls at Ò10 oÕclockÓ. Turn on the main power switch and use either a wireless microphone or cabled microphone to adjust the master volume.
Tape & CD
The main power switch does not control the CD and Tape recorder. A separate power switch is combined with the Tape/CD volume control to limit battery drain when the Tape or CD are not being used.
Wireless Receivers
There are two (2) independent combination XLR/1/4Ó jacks for using microphones with cables. Each jack has a volume control which eects the loudness of both wired and wireless microphones. Also each has a ÒVoice/MusicÓ switch. On ÒmusicÓ program the sound is full delity, while on ÒvoiceÓ the sound is tailored to give maximum projection while limit - ing battery drain.
3
