Extron electronic DP DA2 manual Application Diagram, TouchLink, Tcp/Ip

HDCP visual confirmation — Provides a green signal when encrypted content is sent to a non-compliant display. A full-screen green signal is sent when HDCP-encrypted content is transmitted to a non-HDCP compliant display, providing immediate visual confirmation that protected content cannot be viewed on the display.

Key Minder® — Authenticates and maintains continuous HDCP encryption between all input and output devices to enable simultaneous distribution of a single source signal to two or more displays.

Automatic input cable equalization — Up to 25 feet (7.6 meters) at 2560x1600 @ 60 Hz with Extron DisplayPort cables. Conditions incoming digital signals to compensate for signal loss from long cables, low quality cables, or source devices with poor DisplayPort signal output.

LED indicators — Provide real-time feedback and monitoring of key performance parameters by indicating signal presence and HDCP authentication. The tri-color EDID LED indicator on the back panel shows whether an internal or external EDID is stored.

RS-232 serial control — Allows control by SIS™ commands either via the controller or directly from a PC using the front panel USB port or the rear panel 3-pole captive screw connector.

Output muting control via RS-232 or contact closure — Provides the capability to mute one or both outputs at any time. This allows content to be viewed on a local monitor prior to appearing on the main presentation display.

Application Diagram

TouchLink

Control

System

Extron

DP DA2

DisplayPort

Distribution

Ampli￿er

EDID	T
DEFAULEXTEND
EDID
STORE	NORMAL
	D
STORE

OUTPUTS 2

1

			2	T
	DA			INPU
DP
POWE		R
		X
12V MA
0.6A

TCP/IP

REMOTE
			MUTE
RS	-232
			1	2
	Rx	G
Tx

Flat Panel Displays with DisplayPort Inputs

PC with DisplayPort Output

Figure 1. Typical DP DA2 Application

DP DA2 • Introduction 2