Rear Panel Features
Power Supply
The provided 12 VDC power supply connects to this
1.Connect the captive screw connector from the power supply to the power receptacle.
| POWER | Rear Panel | ||
12V |
|
| ||
| ||||
0.6 A MAX | Power Receptacle | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DC Power Cord
Captive Screw Connector
–
+12 VDC
POWER 12V 
0.6 A MAX
Smooth 
Ridges
A | A |
SECTION
Power Supply
Output Cord
3/16"
(5 mm) Max.
External
Power Supply
AC Power Cord (12 VDC, 1 A )
Figure 4. Power Connections
ATTENTION: • Power supply voltage polarity is critical. Incorrect voltage polarity can damage the equipment. Identify the negative (or ground) lead by the ridges on the side of the cord (see the figure above).
•Always use a power supply supplied by or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the end product.
•Unless otherwise stated, the AC to DC adapters are not suitable for use in air handling spaces or in wall cavities. The power supply is to be located within the same vicinity as the Extron AV processing equipment in an ordinary location, Pollution Degree 2, secured to the equipment rack within the dedicated closet, podium, or desk.
•The installation must always be in accordance with the applicable provisions of National Electrical Code ANSI/NFPA 70, article 75 and the Canadian Electrical Code part 1, section 16. The power supply shall not be permanently fixed to building structure or similar structure.
NOTES:
•The ideal length of exposed wire in the stripping process is 3/16 inch (5 mm). If longer than 3/16 inch, the exposed wires may touch, causing a short circuit. If shorter than 3/16 inch, the wires can be easily pulled out even if tightly fastened.
•Do not tin the wires. Tinned wire does not hold its shape and comes loose over time.
2.Connect the AC power cord of the power supply unit to a 110 or 220 VAC electrical source. When the unit is receiving power, the front panel LED shows a green light.
DP DA2 • Panel Features | 4 |
