Setup
This section provides an overview of how to connect and configure the DP DA2.
1.Place the DP DA2 in a suitable location.
2.If necessary, connect the DP DA2 to a control PC using either the rear panel
3.Power on the DP DA2 (see page 4) and the PC and configure the DP DA2 as required, using SIS commands (see page 15).
4.Connect up to two display devices to the rear panel output connectors (see page 5). To record EDID (see page 6), the display with the lowest resolution should be connected to output 1.
NOTES:
•Both display devices must have resolution equal to or higher than the EDID values being used.
•Extron recommends that the displays connected to outputs 1 and 2 are the same model or have the same native resolution.
5.Power on the display devices.
6.If necessary, record the EDID from the device connected to output 1 (see page 6).
7.Select the correct settings for DIP switches 1 and 2 (see page 7).
8.Connect the source device to the rear panel input connector (see page 5).
9.Power on the source device.
DP DA2 • Setup | 12 |
