Califone PA919SD owner manual PA919PS Specifications, Non-powered Companion Speaker PA916-SP

	PA919PS Specifications
Acoustic Speaker Compliment
Woofer	10” Diameter, 40 Oz. Magnet, 2” Dia. Voice Coil, 6 Ohm
Tweeter	Compression Horn Driver, 12 Oz. Magnet, 1”Voice Coil, 8 Ohm
Frequency Response	45Hz to 18KHz
Amplifier	90 Watts RMS @ 5% THD (AC)
Sound Pressure Level	94 dB, 1 Watt @ 1 Meter
Power Sources	100-240 volt AC switchmode power supply and 12 volt 7 AH
	maintenance-free lead acid batteries (2)
Wireless System

Receiver: One 16-channel selectable UHF diversity wireless receiver 902 ~ 928 MHz (16 channels)

Antennas is hidden internally.

Microphone Transmitters

Handheld wireless microphone or beltpack transmitters optional.

Beltpack transmitter used with choice of hands-free headset, collar or lapel microphones.

Audio Line

Line level XLR jacks (2) providing for attaching PA916-SP speakers via cable. Features volume control for remote speaker(s).

Mixer Panel

Mixer panel accepts one wired XLR microphone. Voice music switch adds emphasis in the voice range for longer range projection. Line-In via dual RCA jacks with volume control. Line-Out via dual RCA jacks. Separate Bass and Treble tone controls. Voice priority switch activates “ducking circuit” which overrides music programs when microphone is used. Speaker mute switch mutes the main speaker plus all other speakers connected. Speaker out. Both switched and unswitched 1/4” phone jacks for connecting speakers.

Dimensions	26 H x 12”W x 10” D
Weight	52 lbs.
Compliance	FCC, CE, C-UL

Non-powered Companion Speaker PA916-SP

	1	Telescoping Handle
		1/4” Phone Jack Speaker In
1	2
		Integral Wheels
	3

The PA916-SP is connected to one of two outputs from the PowerPro or Powered Companion Speaker via SP-50 Cable with 1/4” phone plugs.

Connecting to the “Speaker Out” jack will divide the power between the PowerPro PA919SD or PA919PS and PA916-SP. Connecting to the

2“Switched Out” will disconnect the internal speakers of the PA919SD and deliver all of the power to the PA916-SP.

NOTE:

3There are five (5) LEDs on the front of the speaker, however they are disconnected because there is no internal amplifier or wireless receiver in this passive system.

Mechanical Notations

Telescoping Handle and Wheels

These are only intended for pulling the PowerPro over relatively smooth surfaces. Using the handle to lift or carry the unit or pulling up stairs will cause damage not covered by the warranty.

Tripod Mount

A recess is incorporated on the bottom of all PowerPro Speakers for mounting to the TP-50 tripod.

19 20

califone_919SD_manual_rev1.indd 22-23

6/22/09 1:22 PM