FRONT PANEL CONTROLS
azur 640A
Integrated Amplifier
Volume
|
|
| 4 | Bass | 7 | 8 |
|
|
|
|
|
| Treble | Balance |
|
| |
|
|
| Protection |
|
|
|
| |
Standby/On |
| Phones | Speaker B | Direct |
| Aux | CD Tuner/DAB DVD | DMP/MP3 Tape Mon |
1 | 2 | 3 | 5 | 6 |
| 9 | 10 | 11 |
1Standby/On
Switches the unit between Standby mode (indicated by dim power LED) and On (indicated by bright power LED). Standby is a low power mode where the power consumption is less than 10 Watts. The unit should be left in Standby mode when not in use.
2Infrared sensor
Receives IR commands from the supplied Azur remote control.
3Phones
Allows for the connection of headphones with a ¼" Jack plug connector. When the headphones are connected, the loudspeaker relay is released switching off the output to the loudspeakers (speakers A and B).
10Azur integrated amplifier
4Protection
LED flashes to indicate activation of CAP5 protection system. Refer to the CAP5 section of this manual for more information.
5Speaker B
Turns on/off the secondary set of loudspeaker terminals on the back panel. This can be used for listening to an extra set of loudspeakers in another room.
Please note that care should be taken when selecting if two loudspeakers are going to be used on each channel. If the combined resistance measured on the loudspeaker terminals is too low the amplifier may not switch out of Standby mode until a suitable load resistance is detected. For more information refer to the CAP5 section of this manual.
Note: When using two pairs of speakers, use speakers with a nominal impedance of between
