Shure PSM200 manual System Applications, APPLICATION ONE Wireless Set-Up for a Vocalist

ENGLISH

SYSTEM APPLICATIONS

This section presents three typical applications for the PSM200. For more ideas, visit Shure’s website at www.shure.com.

APPLICATION ONE: Wireless Set-Up for a Vocalist

This is the basic wireless configuration of the PSM200 system for a single user, either instrumental or vocal:

1.Connect the vocal mic to INPUT 1 of the P2T TransMixer.

2.Connect SPLIT OUT 1 from the P2T to the Mixing Console.

3.Connect the instrumental mix line out to INPUT 2 of the P2T.

4.Set the P2T and P2R to the same frequency channel.

5.Insert the E2 earphones into your ears and adjust the mix of INPUT 1 and INPUT 2 on the TransMixer.

Wireless

Transmission

Vocal Mic Signal	Vocal Mic
SPLIT OUT
from TransMixer	Band Mix

Mixing Console

APPLICATION TWO: Combination Wired and Wireless Set-Up for a Drummer

The following application uses the P2R as a combination wired/wireless Receiver. The MIX IN jack of the P2R is connected to a click track for the drummer:

1.Connect the drum mix out of the Mixing Console to INPUT 1 of the P2T TransMixer.

2.Connect the band mix out of the Mixing Console to INPUT 2 of the P2T.

3.Set the P2T and the P2R to the same frequency channel.

4.Insert the E2 earphones into your ears and adjust the mix of INPUT 1 and INPUT 2 on the TransMixer.

5.Set the P2R Receiver to a comfortable level.

6.Set the GAIN switch on the P2R to LO.

7.Connect the Click Output to the MIX IN 1/4-inch jack of the P2R and adjust your levels.

Band Mix

Drum Mix

Mixing Console

Click

Track

10