Learning I.R. Codes:
You may teach the AVS550 remote control the codes from up to three other remote controls. Once you have programmed the new codes, the AVS550 remote will operate your entire system.
1.Press and hold the REMOTE SOURCE button (TV, VCR, or CABLE) you wish to program for 3 seconds until the status LED above the ANGLE button illumi- nates a steady GREEN.
2.Face the remote whose command you wish to learn (source remote) towards the small window above the ZOOM button of the ASV550 remote. Keep them approximately
3.Press the button on the source remote that you wish to teach the AVS550 remote. The LED will turn
AMBER.
4.Press the button on the AVS550 remote where you want to assign the new code. When the command was successfully learned the LED on the AVS550 remote illuminates a steady GREEN. If the Green LED flashes, there was an error and you must try again.
5.The remote is now ready to learn the next com- mand. Press the next button on the source remote you wish to learn and repeat the process.
6.Repeat as needed until all the commands you need to operate he system are learned. After 10 seconds of inactivity the remote will leave learning mode, the green LED will extinguish, and the remote control is ready for use.
Hint: Only save the commands you need to use from the source remote. There is usually no reason to save all the commands. It may be easiest to combine selected commands from various sources under one REMOTE SOURCE button. For example, if you always use a cable box or satellite tuner it will be easier to save the TV input source switching and cable box channel selection buttons under TV. You will not need to save the channel commands from the TV.
12
