Cambridge SoundWorks Home Theater System Making Connections, Placement, Decoder Amplifier

Hook and Loop Fasteners: When mounting speakers with hook and loop fasteners, make sure that all surfaces are clean and free of dirt and grease. Hard, flat, unpainted surfaces work best with hook and loop fasteners (see Diagram Q).

Attach the fastener to the speaker first, remove the backing and adhere to the chosen surface.

Q

Decoder Amplifier			Making Connections
Placement			the next page before making any	stereo miniplugs at each end to
			Consult the Wiring Diagram on	Use the signal cable with black
The Decoder Amplifier can be placed on			connections.	connect the rear output of your
			Speaker Connections. Insert	sound card (if present) to the
the desktop, a shelf or any site that
				REAR INPUT of the Decoder
makes the controls convenient.			one satellite’s plug into the
				Amplifier.
	The Power Adapter cord must be		corresponding Speaker Output on
				Power Supply Adapter Connec-
able to reach from the Decoder			the Decoder Amplifier. Repeat
Amplifier back panel to your AC			this process for the remaining	tions. Confirm the power switch is
power receptacle.			satellites and subwoofer.	in the “OFF” position. Insert the
	Place the Decoder Amplifier on a		Signal Connections. Connect	power supply’s AC plug into an
hard, flat surface.			the Dolby Digital/SPDIF output of	appropriate receptacle. Insert the
	There are ventilation slots on the		your signal source to the Decoder	small DC connector into the “15V
bottom and top of the Decoder			Amplifier using the cable with	DC IN” receptacle on the back of
Amplifier’s enclosure. Don’t block the			RCA plugs at each end.	the Decoder Amplifier.
ventilation slots by placing material on			Use the signal cable with green
top of or below the Decoder Amplifier.			stereo miniplugs at each end to
			connect the stereo line output of
		R	your sound card to the LINE IN
			input of the Decoder Amplifier.

8