CL157500AV
and can cause serious personal injury if used with air tools.
11.Always use attachments designed for use with air powered tools.
Do not use damaged or worn attachments.
12.Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition.
13.Always secure workpiece in a vise or clamp.
14.Never point an air tool at oneself or any other person. Serious injury could occur.
Pre-Operation
SET-UP Instructions
Air tools require a supply of clean, dry air at 90 psi (6.2 bar). An air supply system with filter, regulator, and lubricator (FRL) as shown in Figure 1 should be used.
Campbell Hausfeld FRL model PA2104 (3/8 inch) or PA2114 (1/2 inch) is recommended.
Water in the air supply can damage the tool. Drain condensate from compressor tank and filter daily.
All hoses and fittings must be the correct size and tightly fastened. Refer to Chart 1 for minimum sizes.
Tool Air Consumption | Hose ID |
|
|
Less than 9 SCFM @ 100% usage | 1/4 inch |
|
|
9 to 34 SCFM @ 100% usage | 3/8 inch |
|
|
Greater than 34 SCFM @ 100% usage | 1/2 inch |
|
|
Chart 1 - Suggested minimum hose diameter to use based on 50 ft length hose and continuous SCFM rating of tool. The use of fittings and longer hose may require a larger diameter hose to be used.
Do not use hoses or fittings
that are damaged or deteriorated.
Never carry a tool by the hose or
pull the hose to move the tool or a compressor. Keep hoses away from heat, oil and sharp edges. Replace any hose that is damaged, weak or worn.
Option 1: Individual components
Filter Regulator Lubricator
Option 2: 3 piece combo
Filter, Regulator, and Lubricator
Figure 1
www.campbellhausfeld.com3