General DrivingScrews Instructions
(Continued)
Removing Screws
In order to remove a screw from a
workpiece, use the following steps:
• Set the clutch adjusting collar to its
highest setting and set the speed
selector to its lowest "1" setting.
• Install the proper screwdriver bit
into the drill’s chuck.
• Fully depress the REV button.
• Place the screwdriver bit in the screw
head and with enough pressure
exerted on the drill so that it doesn’t
jump out of the screw head, start
the drill to remove the screw.
Maintenance
Cleaning
All plastic parts should be cleaned with
a soft damp cloth. NEVER use solvents
to clean plastic parts. They could
dissolve or otherwise damage the
material.
Failure to Start
Should your tool fail to start, make
sure the battery pack is charged and
installed in the drill.
Battery Service
The battery pack supplied with this
drill will self-discharge and lose some
of its capacity over time. Therefore, if
it is stored unused for a long period of
time, then it may require recharging
before use. In order to get the most
out of your batteries, it is
recommended that the pack be
recharged every 2-3 months and when
doing so, remove the pack from the
charger after 2-3 hours of charging.
Removing/Replacing the Chuck
If there is a need to replace the chuck,
use the following steps to do so:
• Remove the battery pack from the
drill.
• Rotate the clutch collar until its drill
bit symbol aligns with the arrow on
the top of the drill housing.
• Open the chuck jaws fully by
unscrewing the chuck sleeve
counterclockwise (when viewing the
chuck from its end).
• Locate the left-handed screw inside
the chuck and with the proper
screwdriver bit and remove this
screw by turning it clockwise.
• Insert the short arm of a 3/8" hex
key or Allen wrench into the chuck
and tighten the jaws of the chuck on
the flats of this wrench.
• With a hammer or the like, strike the
long arm of the wrench sharply so
that the chuck will turn
counterclockwise.
• Once the chuck has been loosened,
remove the wrench and unscrew the
chuck from its spindle.
• To replace the chuck with another
one, reverse the steps noted above.
Always keep the spindle threads,
chuck threads, and securing screw
free of debris.
Service
Tool
service
must be performed only by qualified
repair personnel and by an
AUTHORIZED SERVICE CENTER. Service
or maintenance performed by
unqualified personnel could result in a
risk of injury.
For information regarding the
operation or repair of this product,
please call 1-800- 424-8936.
9
For Replacement Parts or Technical Assistance, call 1-800-424-8936
Please provide following information:
- Model number
- Serial number (if any)
- Part description and number as shown in parts list
Part
Description Number
Address any correspondence to:
Campbell Hausfeld
Attn: Parts Department
100 Production Drive
Harrison, OH 45030 U.S.A.
Charger – 18V DG024700AV
Battery Pack – 18V DG024900AV
Chuck– 3/8" DG029900AV
Set Screw SX173400AV
DG201800CD