Operating Instructions | Model NB0064 |
Operating The Nailer
(Continued)
2.Pull pusher (B) back until the nail follower falls behind the nails. Insert strip of nails into rear of magazine
(A).
(B)
(A)
3.Do not load with the safety or trig- ger depressed.
4.Always unload all fasteners before removing tool from service. Unloading is the reverse of loading, except always disconnect the air hose before unloading.
ADJUSTING THE NAIL PENETRATION
The NB0064 is equipped with an adjustable depth of drive feature. This allows the user to determine how deep a fastener will be driven into the work surface.
1.Adjust operating pressure so nails are driven consistently. Do not exceed 110 psi.
2.To drive the nail shallower, turn the wheel (C) to right to the extent desired.
(C) 
3.To sink a nail deeper, turn the wheel
(C) to left to the extent desired.
4. Make sure trigger and work contact ele- ment (WCE) move freely up and down without binding or
sticking after each adjustment.
ADJUSTING THE DIRECTION OF THE EXHAUST
The NB0064 is |
|
equipped with an |
|
adjustable direc- |
|
tion exhaust |
|
deflector. This is | Rotate |
intended to allow the user to change the direction of the exhaust. Simply twist the deflector to any direction desired.
CLEARING A JAM FROM THE NAILER
1.Disconnect the air supply from
the nailer.
2.Remove all nails from the magazine (see
Loading/
Unloading).
Failure to do so will cause the nails to eject from the front of the tool.
3.Undo latch by
pulling out and down. The wire latch will disen- gage from the 
hooks on the nose.
4. The door can now be rotat- ed, exposing the jammed fastener.
5. Remove the jammed fasten- er, using pliers or a screwdriv- er if required.
6 Rotate door back into the closed position.
7. Extend the wire latch and place over the hooks on the nose.
8. Close the latch by pushing the latch up and in until the latch snaps into place.
9. Make sure the trigger and work contact
element (WCE)
move freely up movement 
and down without sticking or bind- ing.
Technical Support
Please call our Nailer Hotline at
Fastener And Replacement Parts
Use only
! WARNING genuine Campbell Hausfeld 16 gauge fasteners (or equiv- alent - see Fastener Interchange Information). Tool performance, safety and durability could be reduced if improper fasteners are used. When ordering replacement parts or fasten- ers, specify by part number.
Nailer Repair
Only qualified personnel shall repair the tool and they shall use genuine Campbell Hausfeld replacement parts and accessories, or parts and acces- sories which perform equivalently.
www.chpower.com
5
