Operating Instructions and Assembly Instructions

Airless Paint Sprayers

Assembly Instructions

Tools required:

u3/4 in. or Adjustable Wrench

u5/8 in. or Adjustable Wrench

Assembly

1.Open packaging and check contents.

2.Remove the equipment and all parts from the carton.

3.Attach high pressure hose to pump and spray gun using a 3/4 inch wrench (See Figure Below).

Pump Assembly

Power Switch

Bypass

Tube Clip

Bypass

Tube

Suction

Tube

Pressure

Control

Knob

Outlet

 

Valve

Suction

Prime/

Filter

Spray

 

Control

 

FIgure - Attach hose

Preparation

Airless painting systems, unlike most other power tools, require additional care to ensure proper working order. Following these instructions will significantly increase the likelihood of having a positive paint experience.

It is important that the painting equipment is flush/tested EACH time a new job is started. Each pump is tested at the factory with a fluid that must be flushed from the

system prior to painting. It is also required prior to each successive use to flush the storage lubricant from the system. Flush the system with either water or mineral spirits. Use water if spraying water based coatings or use mineral spirits if spraying oil based coatings.

www.chpower.com

6