Campbell Hausfeld PW167600AV operating instructions Setup and Operating Instructions, Maintenance

Electric High Pressure Washer

Setup and Operating Instructions

THINGS TO REMEMBER

1.Always check the inlet filter for debris.

2.Always reset the Ground Circuit Interrupter (GFCI) each time the unit is plugged into an outlet.

3.Never direct a single point spray at a soft or breakable surface.

GARDEN HOSE CONNECTION INSTRUCTIONS

1.Attach nipple adapter to inlet fit- ting on the unit.

2.Attach quick connect to garden hose.

3.Pull side “A” of quick connect toward garden hose and push onto nipple adapter.

4.Push side “A” of quick connect towards nipple adapter and release.

"A"

Figure 10

SYSTEM CONNECTION

1.Ensure that the power switch is in the OFF position.

2.Attach high pressure hose and gun assembly to the unit.

3.Insert lance into the gun and turn clockwise to positive stop as shown in Figure 11.

Figure 11

4.Connect garden hose as explained in the Garden Hose Connection Instructions.

5.Plug the power cord into a ground- ed outlet and press the reset button on the GFCI as shown in Figure 12.

THIS MUST BE DONE EACH TIME THE UNIT IS PLUGGED INTO AN OUTLET.

Reset

Figure 12

6.Turn the water on.

7.Trigger the gun for 1 minute to release pressure and to remove any air trapped in the system.

8.Turn the OFF/ON switch to the ON position.

The pressure washer is now ready to use on your cleaning application. Please refer to Figure 13 for nozzle fan adjustment.

Rotating the nozzle will vary the spray pattern from approximately a 0o stream to a 60o fan spray.

NOTE: The Turbo Lance is NOT adjustable and cannot be used to apply detergent.

Figure 13

DETERGENT APPLICATION

1.Remove the cap from the detergent tank and pour in UNDILUTED pres- sure washer detergent. Replace cap.

2.Turn the OFF/ON switch to the ON position.

3.Slide nozzle to the low pressure position as shown in Figure 14 and apply detergent.

IMPORTANT: Unit will only apply detergent when adjustable nozzle is used and the nozzle is in the low pressure position.

LOW PRESSURE

HIGH PRESSURE

Figure 14

4.To rinse or return to high pressure, release the trigger and slide the nozzle to the high pressure position.

NEVER SLIDE THE NOZZLE FROM LOW TO HIGH OR HIGH TO LOW PRESSURE WHEN THE GUN IS TRIG- GERED.

Maintenance

1.Never store unit outdoors or where it could freeze.

2.LONG STORAGE PERIODS: When the unit is stored for more than 2 months, run a mixture of 50% antifreeze and water through the pump as follows:

--Remove the high pressure hose and garden hose from the pump.

--Tilt the unit on its side and turn the OFF/ON switch to the ON position.

--Pour 1 cup of the 50% antifreeze and water mixture into the inlet side of the pump.

--Turn the unit OFF. It is now ready for storage.

4