Pressure Washers

High Pressure Soap Lance
Safety Section

This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.

Warning indicates a potentially hazardous ! WARNING situation which, if not avoided, COULD

result in death or serious injury.

Caution indicates a potentially hazardous ! CAUTION situation which, if not avoided, MAY result

in minor or moderate injury.

 

NOTICE

 

Notice indicates important information

 

 

information that, if not followed, may

 

 

 

 

 

 

cause damage to equipment.

!WARNING

•Do not spray flammable liquids such as gasoline.

3.To attach lance to spray gun, push brass end of lance into gun and twist.

NOTICE

•Follow manufacturer’s label directions for correct concentration of soap/detergents.

•When not in use, always keep in “off” position to prevent leakage.

!CAUTION

•To prevent accidental exposure to cleaning chemicals or possible leaking, do not store detergent in tank when not in use.

To Fill Soap Tank

1.Slide connector tube off hose barb.

2.Optional: For easier filling, detach tank from lance.

•Never place eyes or face close to water spray or attachments.

•Keep away from children. This product is not intended for recreational use by children.

•Do not drink from this device.

3.Remove cap assembly by rotating cap counterclockwise 1/4 turn to align arrow on cap with tab on tank (Figure 2). Pull cap off.

!CAUTION

•To prevent water supply contamination, only use this product when a back flow prevention device is present.

Description

The High Pressure Soap Lance is an accessory that connects to the gun of your pressure washer. With this device you can spray liquid soap at high pressure from a tank conveniently attached to the lance, or you can spray soap at low pressure from the existing soap injection system on your pressure washer. Use the high pressure soap spray to get to those hard- to-reach areas on your house, truck or RV. Use the low pressure spray for gentle soaking of your vehicle, patio, or deck.

Figure 2

4.Add cleaning solution (Figure 3). See manufacturer's instructions for information on specifications and proper use of cleaning solution.

Assembly Instructions

If lance is not already attached to the tank ...

1.Place the tank on a sturdy, flat surface. Then wedge metal shaft of lance between the three “fingers” on top of tank (see Figure 1). NOTE: The fit is very tight. Use caution to prevent damage. Heating the center finger with a hair dryer will make installation easier.

2.Slide free end of connector tube onto hose barb attached to head of lance (see Figure 1).

Figure 3

5.To replace cap, align arrow on cap with tab on tank, then push cap on and turn clockwise 1/4 turn until it locks into place.

6.If tank was removed, reattach it to metal shaft of lance.

7.Reattach free end of connector tube to hose barb.

Hose barb

“Fingers”

Connector tube

Figure 1

www.chpower.com

14